AquaArm TG
Multipurpose Waterproof Coating
₹2,800.0040 Kg Pack + GST ( 18 % )
Fast Shipping
400+ Products
Technical Support
Trusted Quality
Description
AquaArm TG is a cementitious, polymer dispersion based flexible protective coating and waterproof barrier. This product is two-component and resistant to water, moisture and abrasion. Its liquid mixing component is solvent free. AquaArm TG is a stand-alone product. It can be top or over coated with flexible or rigid mortars, stuccos or coatings for uniform appearance.
Features and Benefits
- Breathable
- Flexible
- Self-Curing
Uses
- Balconies, Chajjas
- Toilet / Bathrooms
- Roof & Terraces
Packaging
Consumption
Technical Data
| Property | Value |
|---|---|
| Powder Component | Sand/Cement |
| Liquid Component | Modified Acrylic Polymer Dispersion |
| Mixing Ratio (Powder: Liquid) | 30:10 |
| Tensile Strength | 0.86 N/mm2 |
| Elongation (at 30°C) | Approx. 40% |
Application Methodology
Step No. 1: Surface Preparation
The substrate/surface must be sound, clean and allow good surface adhesion so the material can bond well into the concrete. Horizontal areas should have a rough surface. Smooth surfaces must be mechanically abraded to achieve good bonding.
Clean the surface to remove all loose particles. Repair all cracks, honeycombs, and blemishes on the concrete surface. Crack and wall joints should be treated with Aso Joint Tapes.
Step No. 2: Product Mixing
AquaArm TG comes in a pre-weighed composite bag of powder (Component A) and polymer liquid (Component B). Mix in the ratio of 7.5:2.5 parts by weight in a clean container using a slow-speed drill (350-400 rpm) fitted with a paddle.
Mix for 3-4 minutes until a homogeneous, lump-free mix is achieved. Add powder to the liquid slowly (do not add liquid to powder). Avoid over-mixing.
Step No. 3: Product Application
The mixed material is to be applied on the prepared pre-wetted surface (SSD conditions) in 2 coats.
The first coat should be applied horizontally, and the second coat should be applied vertically after 4–6 hours at 30°C.
AquaArm TG should typically be applied at 1.5–2.5 kg/m² (subject to application requirements).
By brush
AquaArm TG is applied using a soft bristle brush. The application is simple and manual.
Curing of AquaArm TG
- Self-curing under normal conditions.
- Can be exposed to rain (vertical surfaces) after ~4 hours at 30°C.
- Can be exposed to rain (horizontal surfaces) after ~12 hours at 30°C.
- Foot traffic allowed after ~2 days at 30°C.
Health & Safety
AquaArm TG may cause irritation due to its Cementitious nature. On job sites, Applicators should wear protective clothing, gloves, face mask, safety shoes and helmets.
Storage and Shelf Life
- Best before 12 months from the date of manufacture, when stored in cool and dry place at original, unopened condition.
Reviews
Clear filtersThere are no reviews yet.