ArmGrout Inject EP-LV Epoxy Injection Grout
Ultra-Low viscous epoxy resin injection Grout
₹3,555.004.5 Kg Pack + GST ( 18 % )
Fast Shipping
400+ Products
Technical Support
Trusted Quality
Description
ArmGrout Inject EP-LV is Low-viscosity two-part epoxy injection grout for sealing fine to medium cracks (0.2–10 mm) in concrete and RCC structures.
Features and Benefits
- Low-viscosity epoxy injection grout for deep crack penetration
- Suitable for sealing finest structural cracks
- High compressive, tensile & flexural strength
- Strong adhesion to concrete with no bond loss
Uses
- Ideal for repairing and rehabilitating structures with hairline cracks
- Fills cracks in roof slabs and concrete members to restore strength
- Low-viscosity epoxy injection grout for fine cracks and honeycombs
- Strengthens high-density concrete structures
Packaging
4.5 Kg composite pack (B+H)
Consumption
Technical Data
| Property | Value |
|---|---|
| Mixed Viscosity @ 30°C | Approx. 1 Poise |
| Mixed Density (g/cc) | Approx. 1.04 |
| Tensile Strength – 7 Days | Approx. 24 N/mm² |
| Flexural Strength – 7 Days | Approx. 55 N/mm² |
Application Methodology
Step No. 1: Surface Preparation & Crack Sealing
Ensure the concrete surface is clean, dry, and free from dust, oil, grease, laitance, or loose particles. Identify all cracks requiring treatment.
Seal the cracks using a suitable epoxy sealing compound, which can also be used for fixing injection nipples. Install injection nipples along the crack line at a spacing of 200 mm to 500 mm, depending on the width and depth of the crack. Allow the sealing compound to cure properly before injection.
Step No. 2: Mixing & Injection
Pour the entire contents of the hardener pack into the base resin container.
Mix thoroughly using a slow-speed power mixer for approximately 60 seconds until a uniform, lump-free mixture is obtained. Transfer the mixed material into a suitable pressure injection pump. Inject the low-viscosity epoxy grout into the cracks, starting from the lowest nipple and progressing upward, ensuring complete penetration.
Injection must be completed within the pot life of the material for effective bonding.
Step 3: Finishing & Curing
After 24 hours, remove the injection nipples carefully.
Seal the nipple holes and any remaining surface voids using the same sealing compound. Allow the treated area to cure fully before subjecting it to service loads.
Health & Safety
ArmGrout Inject EP-LV should be handled with gloves. When come in contact with skin, eyes or other parts of the body clean with plenty of water and soap and medical advice has to be taken.
Storage and Shelf Life
- Best before 12 months from the date of manufacture, when stored in cool and dry place at original, unopened condition.
Reviews
Clear filtersThere are no reviews yet.