Application:

Mortar:

AquaArm Proof IWP-10 is recommended for use in all sand/cement mortars where it is required to reduce permeability to a minimum.

Concrete:

It is recommended for all general mass concrete work where the risk of porosity and permeability must be minimized.

Instruction for Use:

Product should be mixed with gauging water or can be added to concrete during the process of mixing. The mixing should be continued for at least one to two minutes after the addition of AquaArm Proof IWP-10.

Dosage:

It is normal recommended dosage is 150–200 gms per bag of cement.

Effect of Over Dosing:

An overdose of double the intended amount of product will result in an increase in retardation as compared to that normally obtained at the intended dosage. This effect is found in most of the waterproof admixtures; only the degree may vary. Overdose may also cause increased air entrainment, which will tend to reduce strength. The gauging should be properly adjusted taking into account the water reduction brought about due to the presence of Product. The exact quantity of AquaArm Proof IWP-10 to be admixed in production of waterproof concrete conformed to particular standards is best determined by conducting preliminary site trials.